bdsmboy26:

Tutorial
Tuesday: Multi-functional Bondage Stool

Part
1: A cheap wooden stool, a drill, and some eyebolts = Several hot
bondage predicaments

Safety:

As
always, make sure bdsm/kink play is safe, sane, and consensual. Never
leave your sub alone during bdsm play. Prepare everything needed
before restraining your sub so there’s no need to step away until
after you’ve released him. When using rope or any tightly fitting
cuffs, always periodically feel your sub’s hands/feet/balls
(whatever is tied) to ensure they aren’t cold. Cold is a sign of
circulation loss which needs to be addressed immediately by removing
the restraints in that area before your sub gets hurt.

Specific
to this week’s tutorial, make sure your sub is balanced on the
stool and that it doesn’t tip over, especially when he’s tied/cuffed
to it. Although it’s sturdy, anything is possible. Safety first!

Parts
list:

1. A
cheap
wooden stool with square legs

(not round). These
stools

work perfectly for this and the next 2 parts of this tutorial,
they’re pretty cheap, and they come in a set of 2. Use the other as
an actual stool, or parts for future kinky creations. The price of
these fluctuate, but I’ve seen them as low as about $39 for 2.

image

2. Several
5/16
inch x 3 ¼ inch eyebolts

with nuts and washers to fit them (I recommend 8 eyebolts, or a
minimum of 4)

3. A
drill with a 5/16 inch drill bit

image

4. Locking
leather cuffs
,
and/or some rope

Implementation:

Eye
bolts will probably work best near the bottom of the stool, and just
under the seat. Lay the stool on its side. Choose the sides where you
want to install your eyebolts, then mark and drill holes
approximately 3 inches from the bottom of each leg (centered
horizontally on each leg). Use a 5/16 inch drill bit, but you’ll want
to slide the drill bit in and out a few times after the hole is
drilled to allow the eyebolts to go in more easily.

image
image

Repeat
step 1 approximately 3-4 inches below the seat of the stool, on each
leg.

Slide
an eyebolt through each hole that you drilled using washers on both
sides of the leg, eyebolt side facing out, and use a nut to secure it
in place.

image
image

Now
you can use your new bondage stool to secure your sub in just about
any way you can imagine. Below are a few examples to get you started.

Have
your sub lay over the stool with his cuffed hands and feet at the
bottom of each leg, then clip or padlock the cuffs to the eye bolts.

This position is great for anything from tickle torture to oral service or using his vulnerable ass at the perfect height.

image
image

You
can even secure his balls to one of the horizontal dowels on the
stool to give him something more to think about while he’s there. If
you use a bungee cord, you can tighten it more over time to reduce
his ability to move around.

image
image

Or,
use a similar position, but have your sub lay his back on the stool
instead.

image
image

And
you can do the same with his balls in this one too.

image
image

He
might even REALLY like it. 😉

image

While
he’s on his back, those nipples will be extremely vulnerable. Why not
take full advantage of that with some clothespins?

image

Or,
have your sub kneel with his back to the stool and his legs
straddling the stool.

image

Clip/lock his cuffed ankles to eyebolts at the bottom rear. You can optionally use some rope to tie around his knees and secure them to the bottom front eyebolts.

image

Then clip/lock his cuffed wrists to the top rear eyebolts, to put him in a bit of a predicament. 

image

Next
week:

A few simple additions to the stool will allow for at least 4 more hot
bondage predicaments involving CBT

Leave a Reply

Your email address will not be published. Required fields are marked *